KaiStaatsTiT080219B 800

AWB Update - August 2, 2019 at  11:53 AM  Today Eliona and I spent from 10 am until after 3 pm with a delegation from the US (https://www.schoolandcollegelistings.com/…/Ailanga-School-P…), learning about their programs and history with the school, and sharing our own experience in the development of the observatory.

From 4-6 we worked with Zacharia and a number of students to balance the telescope before applying the motors. We were confused as to the behavior of the telescope at various angles, but with some diagrams on the white board we recognized that the center of gravity is not symmetrical due to the various, off-center components such as the motor mount block, motor, and spotting scope.

KaiStaatsTiT080219C 800
In this short video (click here to view video), Kai, Zacharia, and Eliona with the students of Ailanga school work to balance the 12" Cave-Cassegrain telescope on both the declination and right ascension axes before mounting the motors. 

We added the small sandbag to one side of the tube to counter the motor and that helped tremendously. The Dec axis is very nearly perfectly balanced. The RA axis yet suffers from an awkward asymmetry, but we believe it may be due to a flat spot in the bearing or bearing housing itself, due to the tendency to return to the same position after certain rotations, and an audible/physical "click" in the same spot.

As there is nothing we can do to counter this, and it is quite subtle, we moved to mount the motors. The RA motor went on easily, and worked out of the box. The Dec motor was a bit tricky to install, as Kai recalled from his work on this area with Dan. What had not been previously recognized is that the threaded Dec shaft is very subtly bent. This causes an increase in friction at certain points, and the slipping of the stepping motor internal to its housing.

We experimented with a loose connection between the Dec shaft and the slip collar around the RA axis, and that allowed the motor to drive Dec flawlessly. So, the Teflon bushing will likely be replaced with a thin layer of foam instead.

Tomorrow should see the completion of the telescope, and if the clouds clear, first light! 

KaiStaatsTiT080219D 800

 KaiStaatsTiT080219E 800

 KaiStaatsTiT080219F 800

 KaiStaatsTiT080219G 800

KaiStaatsTiT080219H 800 

 KaiStaatsTiT080219I 800

 KaiStaatsTiT080219J 800

KaiStaatsTiT080219K 800

KaiStaatsTiT080219M 800

View Kai's Facebook page here.